Pfsense default gateway switching. It would be comfortable to keep it as default and setup...
Pfsense default gateway switching. It would be comfortable to keep it as default and setup my new gateway group as default instead. When using gateway switching instead of policy routing the firewall states are not able to track gateway information which allows the firewall to selectively kill states for specific gateways. However, is there anyway to automatically to switch the default gateway to another one if the current default gateway goes down? Thank you! Dec 4, 2025 · By changing the gateway in the firewall rule, you’re telling pfSense to use the gateway group to determine which WAN connection to use for outbound traffic from your LAN network. To configure, create your gateway group as you normally would. For example, when using a gateway group for the default gateway or as a VPN endpoint, each gateway must be on a separate tier. 0/24 and is the default interface for untagged traffic on that port. Aug 27, 2025 · On This Page Policy routing Gateway Groups Failover Load Balancing Monitor IP Addresses What constitutes failure? State Killing/Forced Switch Default Gateway Switching Multi-WAN Terminology and Concepts This section covers terminology and concepts necessary to understand the deployment of multi-WAN functionality with pfSense® software. My new network for infrastructure like the router, APs and switch uses 192. 85. Right now every time I want to switch between them, I've got to manually log into the firewall, go to the system-routing page, pick one from the drop down, then save and apply. pebhdrvrdbtmfkmmufweuoqajeqmognwhmfxipgjdyzydudhw